TYPES OF RAM

Top L-R, DDR2 with heat-spreader, DDR2 without heat-spreader, Laptop DDR2, DDR, Laptop DDR
1 Megabit chip - one of the last models developed by VEB Carl Zeiss Jena in 1989

Modern types of writable RAM generally store a bit of data in either the state of a flip-flop, as in SRAM (static RAM), or as a charge in a capacitor (or transistor gate), as in DRAM (dynamic RAM), EPROM, EEPROM and Flash. Some types have circuitry to detect and/or correct random faults called memory errors in the stored data, using parity bits or error correction codes. RAM of the read-only type, ROM, instead uses a metal mask to permanently enable/disable selected transistors, instead of storing a charge in them.

As both SRAM and DRAM are volatile, other forms of computer storage, such as disks and magnetic tapes, have been used as persistent storage in traditional computers. Many newer products instead rely on flash memory to maintain data when not in use, such as PDAs or small music players. Certain personal computers, such as many rugged computers and netbooks, have also replaced magnetic disks with flash drives. With flash memory, only the NOR type is capable of true random access, allowing direct code execution, and is therefore often used instead of ROM; the lower cost NAND type is commonly used for bulk storage in memory cards and solid-state drives.

[edit] Memory hierarchy

Many computer systems have a memory hierarchy consisting of CPU registers, on-die SRAM caches, external caches, DRAM, paging systems, and virtual memory or swap space on a hard drive. This entire pool of memory may be referred to as "RAM" by many developers, even though the various subsystems can have very different access times, violating the original concept behind the random access term in RAM. Even within a hierarchy level such as DRAM, the specific row, column, bank, rank, channel, or interleave organization of the components make the access time variable, although not to the extent that rotating storage media or a tape is variable. The overall goal of using a memory hierarchy is to obtain the higher possible average access performance while minimizing the total cost of entire memory system. (Generally, the memory hierarchy follows the access time with the fast CPU registers at the top and the slow hard drive at the bottom.)

In many modern personal computers, the RAM comes in an easily upgraded form of modules called memory modules or DRAM modules about the size of a few sticks of chewing gum. These can quickly be replaced should they become damaged or too small for current purposes. As suggested above, smaller amounts of RAM (mostly SRAM) are also integrated in the CPU and other ICs on the motherboard, as well as in hard-drives, CD-ROMs, and several other parts of the computer system.

[edit] Swapping

If a computer becomes low on RAM during intensive application cycles, the computer can perform an operation known as "swapping". When this occurs, the computer temporarily uses hard drive space as additional memory. Constantly relying on this type of backup memory is called thrashing, which is generally undesirable because it lowers overall system performance.

[edit] Other uses of the "RAM" term

Other physical devices with read–write capability can have "RAM" in their names: for example, DVD-RAM. "Random access" is also the name of an indexing method: hence, disk storage is often called "random access"[citation needed] because the reading head can move relatively quickly from one piece of data to another, and does not have to read all the data in between. However the final "M" is crucial: "RAM" (provided there is no additional term as in "DVD-RAM") always refers to a solid-state device.

[edit] RAM disks

Software can "partition" a portion of a computer's RAM, allowing it to act as a much faster hard drive that is called a RAM disk. Unless the memory used is non-volatile, a RAM disk loses the stored data when the computer is shut down. However, volatile memory can retain its data when the computer is shut down if it has a separate power source, usually a battery.

[edit] Shadow RAM

Sometimes, the contents of a ROM chip are copied to SRAM or DRAM to allow for shorter access times (as ROM may be slower). The ROM chip is then disabled while the initialized memory locations are switched in on the same block of addresses (often write-protected). This process, sometimes called shadowing, is fairly common in both computers and embedded systems.

As a common example, the BIOS in typical personal computers often has an option called “use shadow BIOS” or similar. When enabled, functions relying on data from the BIOS’s ROM will instead use DRAM locations (most can also toggle shadowing of video card ROM or other ROM sections). Depending on the system, this may or may not result in increased performance. On some systems the benefit may be hypothetical because the BIOS is not used after booting in favor of direct hardware access. Of course, somewhat less free memory is available when shadowing is enabled.[2]

[edit] Recent developments

Several new types of non-volatile RAM, which will preserve data while powered down, are under development. The technologies used include carbon nanotubes and the magnetic tunnel effect. In summer 2003, a 128 KB (128 × 210 bytes) magnetic RAM (MRAM) chip was manufactured with 0.18 µm technology. In June 2004, Infineon Technologies unveiled a 16 MB (16 × 220 bytes) prototype again based on 0.18 µm technology. Nantero built a functioning carbon nanotube memory prototype 10 GB (10 × 230 bytes) array in 2004. Whether some of these technologies will be able to eventually take a significant market share from either DRAM, SRAM, or flash-memory technology, however, remains to be seen.

Since 2006, "Solid-state drives" (based on flash memory) with capacities exceeding 642 gigabytes and performance far exceeding traditional disks have become available. This development has started to blur the definition between traditional random access memory and "disks", dramatically reducing the difference in performance. Also in development is research being done in the field of plastic magnets, which switch magnetic polarities based on light.

[edit] Memory wall

The "memory wall" is the growing disparity of speed between CPU and memory outside the CPU chip. An important reason for this disparity is the limited communication bandwidth beyond chip boundaries. From 1986 to 2000, CPU speed improved at an annual rate of 55% while memory speed only improved at 10%. Given these trends, it was expected that memory latency would become an overwhelming bottleneck in computer performance. [3]

Currently, CPU speed improvements have slowed significantly partly due to major physical barriers and partly because current CPU designs have already hit the memory wall in some sense. Intel summarized these causes in their Platform 2015 documentation (PDF)

“First of all, as chip geometries shrink and clock frequencies rise, the transistor leakage current increases, leading to excess power consumption and heat (more on power consumption below). Secondly, the advantages of higher clock speeds are in part negated by memory latency, since memory access times have not been able to keep pace with increasing clock frequencies. Third, for certain applications, traditional serial architectures are becoming less efficient as processors get faster (due to the so-called Von Neumann bottleneck), further undercutting any gains that frequency increases might otherwise buy. In addition, partly due to limitations in the means of producing inductance within solid state devices, resistance-capacitance (RC) delays in signal transmission are growing as feature sizes shrink, imposing an additional bottleneck that frequency increases don't address.”

The RC delays in signal transmission were also noted in Clock Rate versus IPC: The End of the Road for Conventional Microarchitectures which projects a maximum of 12.5% average annual CPU performance improvement between 2000 and 2014. The data on Intel Processors clearly shows a slowdown in performance improvements in recent processors. However, Intel's new processors, Core 2 Duo (codenamed Conroe) show a significant improvement over previous Pentium 4 processors; due to a more efficient architecture, performance increased while clock rate actually decreased.

[edit] Security concerns

Contrary to simple models (and perhaps common belief), the contents of modern SDRAM modules are not lost immediately when the computer is shut down; instead, the contents fade away, a process that takes only seconds at room temperatures, but which can be extended to minutes at low temperatures. It is therefore possible to get hold of an encryption key if it were stored in ordinary working memory (i.e. the SDRAM modules).[4] This is sometimes referred to as a cold boot attack.

[edit] See also
Sister project Wikimedia Commons has media related to: RAM

* CAS latency (CL)
* Dual-channel architecture
* ECC (Error-correcting code)
* Registered/buffered memory
* RAM parity

[edit] Notes and references

1. ^ Strictly speaking, modern types of DRAM are therefore not truly (or technically) random access, as data are read in burst; the name DRAM has stuck however.
2. ^ "Shadow Ram" (HTML). http://hardwarehell.com/articles/shadowram.htm. Retrieved on 2007-07-24.
3. ^ The term was coined in Hitting the Memory Wall: Implications of the Obvious (PDF).
4. ^ Cold Boot Attacks on Encryption Keys

[edit] External links
Retrieved from "http://en.wikipedia.org/wiki/Random-access_memory"
Categories: Computer memory
Hidden categories: All articles with unsourced statements | Articles with unsourced statements since March 2009
Views

* Article
* Discussion
* Edit this page
* History